Saltar al contenido principal

Pneumatics

1. Cylinder1-5​

5 pneumatic cylinders with different appearances, you can program the PLC outputs to move forward and backward (if backward PLC out is set to -1, the cylinder works as monostable valve, this is when the PLC advance output is on the cylinder advance and when the output is off, moves backward).

These components are useful when a dynamic element is linked to it, using the FixedDynamicElement and HingeDynamicElment properties (only one can be active), you must to set the Dynamic element id in these properties in order the dynamic element will move linked to the cylinder. The FixedDynamicElement fixes the dynamic element as if where solder to the cylinder, the HingeDynamicElment creates a hinge joint connection between the cylinder and the dynamic element allowing a connection movement in the axis of the cylinder union.

Pneumatic Cylinders

2. Pneumatic Push​

A device used to push parts, uses two PLC dig. Outputs to advance/back and to PLC dig. Inputs to inform about the piston position (advanced/back).

Pneumatic Push